如何用刀口尺檢定鑄鐵平板工作面的平面度
時間：2016/2/4 13:35:10
瀏覽量：588
對于尺寸小于400mm×400mm的研磨平板，可用刀口尺與量塊比較檢定。所有檢定工具應符合下表的規定。
For grinding flat plate with size less than
400 mm * 400 mm, it can be verified by comparing the tool-edge ruler with the
measuring block. All verification tools shall comply with the provisions of the
table below.
|
平板準確度級別
Plate Accuracy Level
|
檢定工具
Verification tool
|
|
0級Level 0
|
0級刀口直尺及2級量塊
Grade 0 cutter edge ruler and grade 2
gauge block
|
|
1級Level 1
|
1級刀口直尺及2級量塊
Grade 1 cutter edge ruler and grade 2
gauge block
|
|
2級Level 2
|
|
用刀口尺及量塊檢定時，在平板被檢截面的兩端放置兩塊尺寸相同（1mm或者2mm）的量塊，將刀口尺放在量塊上，在截面被檢點用微米組量塊向刀口尺與平板間的間隙試塞，則量塊組剛剛?cè)霑r(shí)的尺寸與兩端量塊的尺寸差即為被檢點對兩端點連線的偏差。根據評定原則進行數據處理，求得鑄鐵平板工作面平面度。
When calibrating with a knife-edge ruler
and a measuring block, two measuring blocks of the same size (1mm or 2mm) are
placed at both ends of the section inspected on the flat plate, the knife-edge
ruler is placed on the measuring block, and the gap between the knife-edge
ruler and the flat plate is plugged with a micron group measuring block at the
point inspected on the cross-section, then the difference between the size of
the measuring block group just inserted and that of the measuring blocks at
both ends is the measured block. Deviation of checkpoint to connection of two
endpoints. According to the evaluation principle, data processing is carried
out to obtain the flatness of the cast iron plate working face.
Company name: botou zhuoyuan mechanical equipment manufacturing co.,LTD
Registered
address: jiaohe development zone, botou city, hebei province
Fax
number: 0317-8031093
Contact
information: 15369812793 (WeChat with the same number) liansheng chu
Postcode:
062151
Enterprise
email:1358827475@qq.com
Account
Opening Bank: Botou Branch of Bank of China
Account
number: 100399943203
Agricultural
bank account number: 6228481739059615270
http://zhuoyuanjixie.com